Plinius 9200 Integrated Amplifier *Good Condition*
Excellent condition with an original packaging.
The 9200 integrated amplifier is right on message. It's easy to use while having enough features to keep most purists happy. There are plenty of inputs, even a phono stage, and the option of both balanced and unbalanced connections. A power output of 200 watts per channel means this amplifier will be happy driving most price-compatible speakers to decent levels even in large rooms. Not something that can always be said about lower-powered alternatives.
The Plinius 9200 retains many of the things it predecessors were loved for, such as low noise, low distortion, the J-FET input circuitry, and application of the very best of discrete components. This has resulted in a level of refinement that is hard to miss. It shows up particularly in the top-end, both in extension and quality. The 9200 has a very nice sounding phono stage. It’s as good as most thousand to fifteen hundred dollar phono preamps; the only thing is, it’s not as versatile. The phono stage was not labeled either for MM or MC; instead, it can be set to HIGH (61dB) or LOW (54dB) gain for MM or MC cartridges by means of jumpers inside the amp. This is a little trouble, but not complicated.
POWER: 200 watts RMS per channel into 8 ohms.280 watts RMS per channel into 4 ohms. Both channels driven from 20Hz to 20kHz atless than 0.2% total harmonic distortion
FREQUENCY RESPONSE: 20Hz to 20kHz +/–0.2dB–3dB at 5Hz and –3dB at 70kHz
DISTORTION: Typically <0.05% THD at rated power0.2% THD and IM worst case prior to clipping
CURRENT OUTPUT: 40A short duration peak per channel Fuse protected
HUM & NOISE: 90dB below rated ouput 20Hz to 20kHzunweighted
GAIN: Line inputs to speaker out: 40dB Phono Input To Pre-Out: 66dB on high gain,60dB on low gain
INPUT IMPEDANCE: 47k ohms all inputs
INPUT OVERLOAD:5V RMS
RATED PRE OUT LEVEL: 1.5V RMS into 47k ohms or higher
PRE OUT SOURCE IMPEDANCE: Typically 1.5k ohms
PRE OUT MINIMUM RECOMMENDED LOAD: 47k ohms
TAPE OUTPUT LEVEL: 190mV at 200 ohms. Tape loop muting at 5V RMS input
POWER/CURRENT CONSUMPTION: 600VA0.4A (92W) Class AB Idle
DIMENSIONS: Height: 120mm (4.75')Width:450mm (17.75')Depth: 400mm (15.75')
Return & Refund Policy
• All Pre-Owned items have been tested before listing.
• NO WARRANTY.
• We encourage buyers to test and verify the equipment condition at our showroom (1 Coleman Street, The Adelphi, Unit 03-35) — pre-owned condition as shown on our listed page.