Concert Fidelity ZL-120 Monoblock Amplifier *Very Good Condition*
Good condition. No box.
The ZL-120's sonic character perfectly complemented that of the line stage. Speak about clarity and transparency to die for!. Transients were uncoiled with speed and precision. Low-level detail appeared to bubble to the surface of a recording without attendant grain or brightness. Subjective distortion levels remained low even when driven hard, always an issue with solid-state power amplifiers. Tonally, its character hovered around neutrality. This was not a romantic sounding amplifier. If your system is in need of added warmth, you should look elsewhere. If your tastes run towards a soft presentation, then you'll be disappointed. While it's possible for an extended bandwidth design such as the ZL-120 to sound smooth and refined, excessive liquidity.
Unusually for a solid-state amplifier, soundstage spatial impression was nearly 3D while image outlines were nicely fleshed out. Massed voices were readily resolvable. This was no "water color" rendition. Individual voices did not run or blend together into a homogeneous spatial blob and instead were given distinct features. And most important of all, there was plenty of dynamic propulsion. With the right speaker load, all rocket thrusters were engaged. This was no dull, polite, smooth, simply going through the motions performer. It kindled microdynamics with verve. And neither were macrodynamics a problem: it shifted gears from soft to loud with conviction, leaving no doubt about its dynamic reserve.
ZL-120 Power Amplifier
Type: Monoblock power amplifier
Power Output: 120 wpc @ 8 Ohms
Power Bandwidth: 0.5Hz to 100 kHz (-0.8dB)
Frequency Response: 0.5Hz to 30kHz (±0dB), 0.5Hz to 100KHz (-0.8dB)
IMD: 0.1% at rated power, SMPTE 4:1 method
Input Sensitivity: 2V for Rated Power
Input Impedance: 20kOhm (Low), 100kOhm (High)
Voltage Gain: 20dB
Dimensions: 450 x 150 x 360 (WxHxD in mm)
Net Weight: 48 lbs
Return & Refund Policy
• All Pre-Owned items have been tested before listing.
• NO WARRANTY.
• We encourage buyers to test and verify the equipment condition at our showroom (1 Coleman Street, The Adelphi, Unit 03-35) — pre-owned condition as shown on our listed page.